16017 Image IMAGE: stroke flatten tolerance increased by <2,3,4 ...> Green The firmware was unable to calibrate the stroke to the tolerance specified by the "set media <media> stol" parameter, and is therefore increasing the tolerance by the indicated factor. If necessary, the tolerance will be increased up to the limit specified by the "set media <media> ltol" parameter. If the desired exposure level is reasonable, this message can indicate a failing head. The weakest pixels cannot reach the desired exposure level, so the tolerance must be increased. The DAOM calibration also may be inaccurate. Report this message to Creo Service. If no other errors are reported, the platesetter will continue working fine, but may need servicing soon. Exposure level too high Head is failing. DAOM calibration is inaccurate ../nvs/media_cal_stol.xmlNVS: media stol ../nvs/media_cal_ltol.xmlNVS: media ltol ../commands/daom.xmlCommand: daom ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:28 2008 PST